Search
Now showing items 1-10 of 10
Discussion: “Eccentricity Effects on the Rotordynamic Coefficients of Plain Annular Seals: Theory Versus Experiment” (Marquette, O. R., Childs, D. W., and San Andres, L., 1997, ASME J. Tribol., 119, pp. 443–447)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Study on Thermal Behavior of Large Seal-Ring” (Suganami, T., Masuda, T., Oishi, N., and Shimazu, T., 1982, ASME J. Lubr. Technol., 104, pp. 449–453)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Theory Versus Experiment for the Rotordynamic Coefficients of Annular Gas Seals: Part 1—Test Facility and Apparatus” (Childs, D. W., Nelson, C. E., Nicks, C., Scharrer, J., Elrod, D., and Hale, K., 1986, 108, pp. 426–431)
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “Theory Versus Experiment for the Rotordynamic Coefficients of Annular Gas Seals: Part 2—Constant-Clearance and Convergent-Tapered Geometry” (Nelson, C. C., Childs, D. W., Nicks, C., and Elrod, D., 1986, ASME J. Tribol., 108, pp. 433–437)
Publisher: The American Society of Mechanical Engineers (ASME)
Studies of Flows Through N-Sequential Orifices
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Critical mass flux and axial pressure profile data for fluid nitrogen are presented for N = 20, 15, 10, and 7 N-sequential-orifice-inlet configurations uniformly spaced at 15.5 cm. These data ...
Revised International Representations for the Viscosity of Water and Steam and New Representations for the Surface Tension of Water
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The Eighth International Conference on the Properties of Steam has adopted a new skeleton table and formulation for viscosity. The formulation is valid from the triple point to 1100 K (∼2000 ...
A Fully Coupled Variable Properties Thermohydraulic Model for a Cryogenic Hydrostatic Journal Bearing
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The goal set forth here is to continue the work started by Braun et al. [11] and present an integrated analysis of the behavior of the two row, 20 staggered pockets, hydrostatic cryogenic ...
Brush Seal Leakage Performance With Gaseous Working Fluids at Static and Low Rotor Speed Conditions
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The leakage performance of a brush seal with gaseous working fluids at static and low rotor speed conditions was investigated. This report includes the leakage results for air, helium, and ...
Heat Transfer in Thermal Barrier Coated Rods With Circumferential and Radial Temperature Gradients
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: To study the heat transfer in ceramic coatings applied to the heated side of internally cooled hot section components of the gas turbine engine, a mathematical model is developed for the ...
Numerical and Analytical Study of Fluid Dynamic Forces in Seals and Bearings
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A numerical model based on a transformed, conservative form of the three-dimensional Navier-Stokes equations and an analytical model based on “lumped” fluid parameters are presented and compared ...